引用:

原帖由 cc0128 于 2015-1-31 14:39 发表
posted by wap, platform: Android
Osx 很不稳定的说。bug也很多。

建议你重置一次PRAM  方法是关机状态下按开机  然后按下OPTION,COMMAND,P,R四个键   黑屏状态下一共听见三次 “咚”就放手  机器速度会比原来快很多  原理我也不懂  没有后遗症

引用:

原帖由 zxsoft 于 2015-2-2 06:55 发表
posted by wap, platform: iPhone
我好怕'你是在坑他吗？这方法真行？

I post this hoping to help those users who, like me, are experiencing high CPU usage and massive memory leaking with OS X core services and apps, leading to slow performance and battery drain.

I've tried everything mentioned, but found the right combination of steps to follow. I've tried this with seven different Apple computers, including mine, and has worked well so far. I applied this method yesterday to give these process a 24 hour window to fail again, so far everything good.

First step: disconnect any external or secondary monitors, if any is present. The video memory allocation leak can also happen if you have a system with an integrated card, like Intel, with no external monitors attached.

Second step: Shut down your machine and enter Safe Mode (press shift once you turn on your computer again, more info below). Once you're there, fix your disk permissions.

Guide of how to access Safe Mode: OS X: What is Safe Boot, Safe Mode?

Third step: From Safe Mode turn off your machine again and reset your System Management Controller (SMC). There are different methods, depending on machine, to do this. To know what method applies to yours read the following guide.

Intel-based Macs: Resetting the System Management Controller (SMC)

Fourth step: Once your machine completes a full boot after resetting the SMC turn it off again and reset your PRAM (THIS IS THE MOST IMPORTANT STEP, BUT THE PREVIOUS ONES ARE ESSENTIAL FOR THIS ONE TO WORK). The PRAM stores small bits of data that indicate our Apple computer how to interact with the devices connected to it, including monitors and video cards. It also affects software.

To reset it you should hold the OPTION, COMMAND, P and R keys in your keyboard immediately after turning on your machine again.You'll hear the start up chime, continue pressing the keys until the machine boots and the chime starts A SECOND TIME, then release. IF YOUR YOSEMITE INSTALLATION LOCKS UP AT A BLACK SCREEN AFTER THIS, DONT PANIC! It's normal, just turn off your computer and let it boot again.

More info about PRAM: OS X Mavericks: Reset your computer’s PRAM

Voila, reconnect your external displays and enjoy your system.

Message was edited by: Luis_Mercado

MacBook Air, OS X Yosemite (10.10)