After this steps U will have an "SuperSim compatible iPhone".
::Getting IMSI,ICCID & Ki number from your SIMs::
Step 1 - Your SIM
1. Put YOUR SIM card in programer
2. Run Woronscan
3. Click on "Tasks" then on "IMSI select" u will get a IMSI number, write it down.
4. Click on "Tasks" then on "Ki search", in pop-up window just click "Search", and wait,Ki extraction has began.(I was waiting for mine 40 min ) When u get it, write it down.
Step 2 - Getting IMSI,ICCID from AT&T SIM card which came with an iPhone
1. Put your AT&T SIM card in programer
2. Click on "Tasks" then on "IMSI select" u will get a IMSI number, write it down.
3. Click on "Tasks" then on "ICC select" u will get a ICCID number, write it down.
4. Close Woronscan
5. Remove SIM from programer
Now U have all "data" to make SuperSim.
::Making SuperSim::
1. Download & extract http://www.rapi****re.com/files/4693....01_iPhone.rar
1.a Put your Silvercard in programer
2. Run Sim-Emu 6.01 Configurator v2.1
3. Click on Configure tab
4. Click "Read from disk" button
5. Browse to your downloaded Flash&EEPROM files, first double click on SIM_EMU_6.01_iphone.HEX and then double click on SIM_EMU_6.01_iphone_EP.HEX, now they are loaded,positions 0 and 9 are red colored,thats fine.
6. In position 0 , type in YOUR SIM IMSI and Ki, then a AT&T ICCID, for ADN/SMS/FDN# type 161, 15, 4, for SMS Centre type in your carrier SMS center number.
7. Now select position 9, here type only IMSI from AT&T SIM card, NOTHING ELSE!
8. In "Config mode" check "Card" circle button
9. Click on "Write to card" button,when its done, remove card from programer
10. http://www.mobileshop.org/usertech/simcutting.htm
11. Power OFF your iPhone
12. Put your SuperSim in iPhone
13. Power ON iPhone, enjoy! 作者: 眼神 时间: 2007-8-6 08:59