已经装了那个0.1.1什么的驱动程序，能认出来PS3控制器，蓝牙不断叫我重新配对，输入0000无效。

插USB线能用。

ps2手柄接USB转接线也能用。

新买的GC,PS2,XBOX  三合一转PC手柄也能用。还不用驱动。

posted by wap, platform: iPhone

可以无线支持 原生不要任何驱动 但是配对过程非常蛋疼

ls分享下？

There is an extra step in lion for some reason. Never noticed because i originally set up on snow leopard and i guess it caries over the configuration to lion. So I erased the controller form my list of bluetooth devices and saw what you saw. I put in 0000 as the key code and it showed up then disconnected. Repeated same thing. Did some research and here is how to sync up to lion. Did it 3 times already, just to make sure.
Make sure to have the bluetooth preference window open.
Turn on the PS3 controller (after USB sync if not done)
When the passkey comes up, type 0000.
Now look for the cog wheel down below the list of devices and open it. Choose update services. The controller should now show that it is now configured.
Then turn off bluetooth.
Turn it back on and press the PS3 on button to reconnect. It should not ask for a password. Then go to that cog wheel again and add the controller to favorites.
You should have no problems from now on as long you don't delete the controller form the bluetooth menu. You can even sync back and forth between the PS3 and mac without reconfiguring. Just plug in the USB to the device you want to connect to.

反复多试几次肯定能成功，之前把那个第三方驱动删掉。

回头试试！谢谢LS！

引用:

原帖由 starman 于 2012-7-22 21:37 发表
There is an extra step in lion for some reason. Never noticed because i originally set up on snow leopard and i guess it caries over the configuration to lion. So I erased the controller form my list  ...

多谢，已经可以用了！不过4个灯老是在闪的。