posted by wap, platform: iPad
我有最新的SF30Pro，

本来买来指望给Raspberry Pi用，结果……

它现阶段单单就不支持Pi，（官网Pi的图标灰色，灭了的，其他平台全支持）

就想骂娘。首发后，某网站立刻给了10美元折价码，

我们预定了原价的，都是冤大头。

posted by wap, platform: iPad
https://forums.libretro.com/t/8bitdo-gamepad-autoconfigs-udev/3036

要加UDev rules才能用啊。

=_=不会用……

引用:

原帖由 sonicteam 于 2017-12-26 17:01 发表



为什么我就能用呢 蓝牙方式 树莓派3 家里2种树莓派都能用

已经成功接上了！

用开始键开启摇杆，按下背后配对键直到灯号开始左右移动，然后在蓝芽配对选项里搜寻，然后找到SF30PRO，选YES/NO什么的，

之后退出，进入到uDEV选项设置SFPRO，重启。

(REDDIT那里也在讨论怎么接上PRO版)

https://www.reddit.com/r/RetroPi ... nd_8bitdo_sn30_pro/

節錄：

I saw this post and many others on Reddit and elsewhere prior to receiving my SN30 Pro
and was like "Shit. This is a mess.
I should never have bought this thing."

I'm happy to say that I received my SN30 pro today and got it working on the very first try -
flawlessly - using the following instructions:

Right out of the box, update to the latest 8bitdo firmware first. v1.20 as of this post.
Turn on the controller by holding down Start.
Don't screw around with any "modes" or holding down any other buttons. Just hold down Start
until the four lights start to cycle.Pair the controller with Retropie.
Have it add the udev rule.Save changes and restart Retropie.
Setup the buttons within Emulation Station
Hey, look at that. You're all done. It works in all emulators.

The analog sticks' range of motion works great in everything. If your controller gets disconnected
for lack of activity or whatever, just hold down Start (and no other buttons) to turn it on again
and you'll reconnect with 10 seconds or so. No need to reboot or re-pair.

There's never any need to select an alternate mode. Just power it on by holding down Start. Done.

I've been using this for a few hours now and have tried many different disconnection scenarios,
but this seems pretty solid to me so far!

[ 本帖最后由 maidofhonor 于 2017-12-27 03:05 编辑 ]

posted by wap, platform: iPad

引用:

原帖由 @sonicteam  于 2017-12-27 10:26 发表
uDEV选项在哪里可以看到 蓝牙设置里吗  我是配对好后 直接在外面设置手柄按键的

好像是有一个profile必须生成，我也不懂…。

如果单有SF30Pro而没有接另一个USB有线手柄来设置，这样肯定是不行的，

必须有一个先前设置好，已经正常工作的手柄来引导，这样才能注册第二个手柄（SF30PRO）。

我用的是WiiU Pro手柄，当然360手柄等来引导应该也行。